GQ40 Rebar Cutting Machine is suitable for carbon steel, hot-rolled round steel and threaded steel in various reinforced concrete in construction projects. The machine consists of a traveling wheel set, a transmission structure, a machine body, a clutch device, a cutter head, a cutter seat.

Cutting Capacity	II Rebar(≤450N）	≤ø40mm
	III Rebar（≤650N）	≤ø32mm
Cutting Frequency		32times/min
Motor Power		3kw(3 Phase)
Voltage		380v(Customized)
Weight		390kg
Dimension(L*W*H)		1430*600*730

Product Features

1. Crafted from high-quality ductile iron casting, the GQ40 rebar cutting machine boasts a compact and robust body, ensuring reliability and excellent quality in a small, space-efficient design.
2. Enjoy optimal lubrication performance with its box-type closed structure and gear splash lubrication system. After a single refuel, it supports over two months of continuous operation. (Maintain oil levels at or above the marked scale line for sustained lubrication.)
3. Experience reduced functional consumption thanks to enhanced lubrication conditions and the use of rolling bearings on the gear shaft ends. Compared to similar machines, it achieves a one-third power reduction under equivalent loads.
4. Designed for ease of mobility, the GQ40 bar cutting machine features front-wheel steering, facilitating flexible movement and straightforward maintenance.
5. Transparent fixing bolts secure the knife plate, ensuring it remains steadfast and damage-resistant.

Safety and Precautions for Use

(I) Preparations Before Use

1. Manually rotate the machine to ensure proper gear meshing.
2. Confirm the blade is securely installed, maintaining a gap of 0.2-0.5mm between the two blades.
3. Inspect the tightness of all bolts across the machine.
4. Verify the electrical components are in good condition, with proper insulation. Install leakage protection devices and ensure the equipment’s grounding wire is securely grounded.
5. Lubricate all rotating parts thoroughly before operation.
6. Perform a no-load test. If any irregularities are detected, stop the machine immediately for inspection and repair.

(II) Precautions During Use

1. Always place the steel bar at the bottom part of the blade for cutting. Avoid using the upper blade unnecessarily to prevent excessive strain on the machine’s body.
2. Ensure the blade is intact during operation, checking regularly for looseness. Replace or sharpen the blade edge promptly if necessary.
3. If any issues arise during operation, immediately disconnect the power supply and inspect the machine for repairs.
4. Never attempt repairs or adjustments while the machine is running.
5. Ensure all safety guards are in place before starting the machine to prevent accidents.
6. When engaging the clutch, make sure it is fully depressed. Avoid frequent partial engagements, which can lead to premature clutch wear.
7. During cutting, clear any waste material beneath the blade promptly to prevent damage or breakage of the knife plate’s fixing bolts due to excessive pressure.